DIY Deck Cleaning
In this article, we will address how to use the pressure washing equipment for diy deck cleaning. Before a proper deck restoration is completed a deck cleaning must be done first. Proper use of power washing machines is pivotal to achieve your desired results without damaging your deck. Before beginning, be sure to remove all grills, furniture, planters and other items from your deck. Any grease spills from your grill should be pre-treated with a solution of dish soap.
DIY Deck Cleaning
Applying Deck Cleaning Cleansers
Before applying cleanser to the deck, rinse the deck with water. This will aid the cleanser in spreading easily once it is applied. Then, use the scrub brush to apply cleanser to the deck. Most of the work of cleaning the deck will be done by the cleanser, not the pressure washer itself. Many cleaning solutions should not be allowed to dry on the wood. In a DIY deck cleaning it is important to closely follow the manufacturer’s instructions and periodically mist if necessary. Typically the manufacturer will recommend a soaking time of 20 minutes to enable the cleanser to adhere to the embedded dirt.
Rinsing the Deck
After waiting the recommended time for the cleanser to soak, it is time to rinse the deck with your pressure washer. In a DIY deck cleaning, it is important to not let the cleanser soak too long, as this can cause damage to the wood. When first engaging the trigger of the pressure washer, point it away from the deck, people and other objects. If the sprayer is pointed directly at the deck when first engaged, scarring on the deck surface can result.
DIY Deck Cleaning Technique
Cleaning is typically started where the deck is adjacent to the house. Begin sweeping by starting from the edge, then sweep the sprayer out from the house and then back toward it, being careful to maintain a consistent distance between the nozzle tip and the deck to ensure an even result. A typical sweeping section might be about 3 feet wide. Once the first 3 foot section along the length of the house is completed, the next 3 foot strip can be begun.
A technique called “feathering” can be used to prevent lines from appearing between two sweeping sections. To do this, make sure the second sweep overlaps the first sweep, working with the grain or length of the board. An alternative to the sweeping technique is the long sweep, whereby you walk the entire length of a board, making sure to hold the nozzle at a consistent length from the surface. It will typically take a few sweeps to complete one board in this manner. After the whole deck has been washed, allow it to dry for 24 hours, and then re-inspect. Imperfections that were invisible when the deck is wet may appear, and it may be necessary to re-clean some areas.
Contact Carlton Cleans
Although a DIY deck cleaning can be done it is best to leave a project like this to the professionals with years of experience to avoid permanent damages to your deck in a DIY deck cleaning. Contact Carlton Cleans today to schedule your deck cleaning.